Sentence examples for effluent mass from inspiring English sources

Effluent mass flux values were normalized by the up-gradient DNAPL distributions.

Quantifying tetrachloroethylene (PCE) saturation in layered media was determined using PTT and effluent mass determinations.

Total effluent mass loads of TP must be reduced by 40% from a baseline established in 1991.

A Tetrachloroethylene (PCE) spill was performed into six source zone models of increasing heterogeneity, and both the spatial distribution of the dissolution behavior and the net effluent mass flux were examined.

Effluent mass flux due to water dissolution was also found to increase progressively due to the increase in NAPL-water contact area even though the PCE mass was reduced.

For each solute, one would measure the solute concentration in the hemofiltrate, calculate daily losses using effluent volume and then calculate mass balance based on the levels in plasma, replacement fluid or any other infusion prescribed.

A single stage batch adsorber was designed for different adsorbent mass/treated effluent volume ratios using the Langmuir isotherm.

Predicted effluent concentrations and mass recovery agreed reasonably well with measured values.

Predicted effluent concentrations and mass recovery were also found to depend strongly upon the initial NAPL entrapment configuration.

Based on the observed effluent concentration and mass balance, Tween-80 effectively removed some PCE free phase from the source zone.

The HPLC effluent entered the mass spectrometer through an electrospray capillary set at 3.0 kV at a source block temperature of 100°C and a desolvation gas temperature of 350°C.