Sentence examples for effect of the cutting from inspiring English sources
During the tests, performed at low cutting speed, avoiding thermal effects, and high speed, to investigate about the effect of the cutting velocity on the cut quality, the fibre orientation respect to the cutting direction, the tool rake angle and the depth of cut were varied to investigate their influence on the phenomenon.
For the effect of the cutting angles, results showed that the draught force increased linearly with the cutting and the lifting angles.
The Finite Elements Method (FEM) simulation of the contact between the tool and the workpiece highlights the effect of the cutting edge radius on the first coating fracture and the further wear development.
In contrast, due to the non-monotonic effect of the cutting speed on the surface roughness, only when the spindle speeds were relatively low, the higher ultrasonic amplitude apparently contributed to the hole surface quality further improvement.
The present investigation is an attempt to study the effect of the cutting speed, the feed rate, and the drill point geometry on the residual tensile strength of the drilled unidirectional glass fiber reinforced epoxy composite using the Taguchi method and suggests the optimal conditions for maximum residual tensile strength.
At last, the effect of the cutting parameter on the depth of the SSD layers is studied by information statistics.
A considerable number of studies have researched the effects of the cutting speed, feed, depth of cut, and other factors on the surface roughness.
The effects of the cutting parameters on surface roughness and cutting force were determined by using analysis of variance (ANOVA).
The effects of the cutting parameters and tool materials on surface roughness were evaluated by the analysis of variance.
In this study, the effects of the cutting parameters on the surface quality and burr width were investigated in the micro milling of Ti-6Al-4V alloy.
The effects of the cutting edge shape, the diameter and the edge angle on penetration are analyzed by non-liner transient dynamic analysis using a finite element method (FEM).
