Sentence examples for dynamic measurement using from inspiring English sources
When doing dynamic measurement using an electromechanical transducer for both sensing and actuating simultaneously, loading effect of the transducer is obviously large enough to jeopardize measurement accuracy.
The precision of dynamic measurement using modular DAQ systems is dependent both on the dynamic parameters of the AD module used, and the EMC conditions in the system case.
A test setup for dynamic measurements using a split-Hopkinson pressure bar was developed to achieve valid compressive failure in the specimen's free gauge section.
Prior to B-phycoerythrin purification, the protein adsorption of the vortex flow reactor was characterized through hydrodynamic studies and a dynamic capacity measurement using a standard protein.
Ea was calculated from a single dynamic thermogravimetric measurement using a multiple linear regression (nth order kinetics) method (i.e. the Wyden-Widmann's method [13]), by means of the following Arrhenius type equation: dα/dt = k0 e-Ea/RT (1-α n.
We developed a metric, the reliable range, to quantify the linear region of the dynamic range of measurement using the MTRC analytes.
The size of Si nanoparticles in colloidal suspensions was determined by dynamic light scattering (DLS) measurement using a Zetasizer Nano ZS (Malvern), the samples being illuminated by the 633 nm line of a He-Ne laser and signal was detected in a backscattering geometry.
Micelles were diluted in diH2O to 0.20 mg/mL for hydrodynamic radius measurement using dynamic light scattering (DLS) (Malvern Zetasizer Nano-ZS).
In the Finnish Institute for Occupational Health, standard operating procedures were established for Co and Cr measurement using dynamic reaction cell inductively coupled plasma (quadripole) mass spectrometry (Agilent 7500 cx, Agilent Technologies, Santa Clara, CA, USA).
float distance key, prevValue, CurrValue) Specifies the distance measurement using previous dynamic value and current dynamic value of a key.
SHM of aerospace structures based on dynamic strain measurements using SVM classification has been studied by Loutas et al. (2012).
