Sentence examples for during the initial cycles from inspiring English sources
Capacities greater than 1 eq /TiS3were observed during the initial cycles.
The electron microscopy results indicate that parts of the active material get finer during the initial cycles.
The formation of the SEI layer occurred on the surface of the electrodes due to the decomposition of the electrolyte during the initial cycles [31].
This reflects the fact that both intrinsic and extrinsic defects provided interaction sites for H+ ions, whereas the increased number of defects at the mesh edges enhanced the pH response of the GM-FETs during the initial cycles.
The build-up of pore volume during the initial cycles proceeds essentially through the opening/formation and deepening of narrow micropores (L0 ≈ 0.8 nm), whereas a slight pore widening appears to be the main outcome of further cycles.
When the values of x were 0, 0.25, and 0.5, the reversible capacities of Ni x Co1-xMoO4 nanowire electrodes faded rapidly even during the initial cycles, resulting in a poor reversible capacity of ≈290 mA h/g after 20 cycles.
The propagation along Sendai Coast (Fig. 8) shows that during the initial cycle, with negative polarity, the waves first hit the coastal area south of the Soma station approximately 30 min after the mainshock.
The CV curves show two reduction peaks at around 1.20 and 1.37 V (vs. Zn2+/Zn) as well as one oxidation peak at about 1.53 V (vs. Zn2+/Zn) during the initial cycle.
Because elevated endogenous thrombin potential (ETP) has been found in several studies to be a VTE risk factor, we evaluated the extent of ETP changes during the initial cycle of an ethinyl estradiol (EE) and levonorgestrel (LNG) COC.
A micro-island structure of the active material was confirmed to be self-organized during the initial cycle, and such a structural change of the active material was compared with that of other Sn-based electrodes.
The capacity recovered to 451 mAh g−1 when the current density was switched to 100 mA g−1, which was close to the value obtained during the initial cycle, demonstrating the good electrochemical reversibility and structural stability during the charge/discharge process.
