Sentence examples for during digitization from inspiring English sources

Whatever the chosen resolution, our method requires that the LSM data be properly deconvolved in order to reduce the optical smearing introduced by the point spread function (PSF) of the microscope as well as to filter out any shot noise created by the CCD camera during digitization.

Signals were filtered at 10 kHz and subsequently at 2 kHz during digitization (10 kHz).

Approximately a month later, in a second group session, participants were asked to check whether any mistakes had been made during digitization, and to review and refine the ordering and relations between the concepts in order to improve the articulation of the knowledge relevant for clerks.

It is possible that this variation results from the small distance between the tip of the 2nd digit and the inner segment of the 3rd digit or difficulty in locating the points during the digitization, but it could also be a highly controllable mechanism to adjust the flow over the wing during flight.

Inadequate contrast between recorded waveform and the background poses a serious problem during the digitization of the historical seismograms, which may be seen in the case of mechanical recording when the paper was insufficiently smoked (Batlló et al. 1997, 2008, 2010; Kanamori et al. 2010).

However, during the digitization sessions for Akuma, Capcom unexpectedly approved the addition of Sheng Long; Noon stated that Capcom had ambitions that the game would crush Mortal Kombat II, and felt the character's inclusion was a necessity for that goal.

The employees are the engine that fuels digital digitization of business.

Pre-digitization curation may also include the application of barcodes, assignment of GUIDs, and creation of a skeletal database record, if these are not completed during proactive digitization or in a later module.

The location of the lumbar segment targeted by the contact hand is traced with three Optotrak smart marker rigid bodies during the HVLA-SM procedure instead of the one-time digitization during the preload phase used by Triano et al. [ 51].

Barcodes should be affixed to sheets prior to recording an image, which might be during pre-digitization curation or in an early step within the imaging workflow, and should be unobstructed and clearly visible in the resulting image to ensure they can be easily and accurately scanned from the image by a barcode reader or read by an optical character recognition (OCR) application.

When the data had to be low-pass filtered to improve the signal-to-noise ratio, either the analog 8-pole Bessel filter of the amplifier was used to condition signals during off-line digitization from the DAT tape or the data were conditioned with the digital Gaussian filters implemented in Fetchan 6 or Clampfit 8.