Sentence examples for dsc run from inspiring English sources
Approximately 5 10 mg of RT21® were used in each DSC run.
In addition to these slow runs, also a fast ASC heating run was made at 32 K h(^{-1}) (approx) 0.5 K min(^{-1}) in the liquid phase, to allow for a comparison with a slow DSC run (see Sect. 4.3). Figure 4 shows (c_p(T)) in comparison with a normal-speed ASC heating run.
Samples were weighed about 5 10 mg, sealed in an aluminum pan of 40 μL capacity, and equilibrated at 25 °C and were subjected to the DSC run over the temperature range of 25 to 350 °C at a heating rate of 10 °C min-1.
The samples were weighed before the DSC run.
No noticeable difference in sample mass before and after each DSC run was detected, indicating that no water evaporation took place during DSC analysis using the Tzero® hermetic aluminum pans.
This broad peak represents the evaporation activity of bound moisture in the Okra gum during the DSC run and it was released through the hole of the aluminium lid.
Likely, the heat-flux calibration during the DSC runs was slightly off.
Open image in new window Fig. 6 DSC runs on RT42. a Specific heat capacity (c_p).
For example, when the DSC runs at a high heating/cooling rate, it will lead to erroneous information.
For the RT42 heating runs, the two ASC runs differ by a factor 20 in nominal rate, and so do the DSC runs.
The glass forming ability of each alloy composition was evaluated based on the thermal parameters obtained from DSC runs and on X-ray diffraction patterns.
