Sentence examples for dry operation from inspiring English sources
Two cases under dry operation are simulated and compared.
New empirical relations are presented for the heat and mass transfer coefficients for wet-operation, Nusselt number for dry operation and air-side loss coefficient for wet and dry operation.
These correlations are compared to corresponding equations from literature, revealing significant deviations for wet operation but smaller differences for dry operation.
The test device was designed for a dry operation, however it is possible after some modifications to perform a wet comminution with a high concentrated slurry.
Single cell tests employing the SPEEK/Pt-Cs2.5 self-humidifying membrane and the plain SPEEK membrane under wet or dry operation conditions and primary 100 h fuel cell stability measurement were also conducted in the present study.
The performance attainable with the novel LU-VE Emeritus® unit equipped with a water spray system and adiabatic panels is compared with those achievable with the same unit in dry operation.
Following an already good knowledge in low speed dry operations including drilling, tapping and threading, the coatings were tested under dry high-speed machining operations (milling and turning) where the temperatures involved are higher.
Toward an understanding of the fuel cell dynamics for dry operations, numerical simulations are carried out for a single channel polymer electrolyte (PEM) fuel cell undergoing step change in cell voltage over wide range of operating conditions.
Drying temperature is considered to be the most important factor in the drying operation.
This paper presents works related to the use of electric radiating technologies in a drying operation.
Drying operation also needs continuous improvements to reduce energy consumption and preserve quality.
