Sentence examples for drop of strength from inspiring English sources

Blood is a useful reminder: Every patient needs to be treated in a way that conserves every drop of strength and resilience.

A drastical drop of strength for RO series was revealed at high water vapor concentration (Fig. 2a, b, mode 3).

In comparison, a 55% drop of strength was observed in a mixture of 50% slag 50% FA (cured at 25 °C) after the same exposure.

However in the model CD_IC many plastic hinges also form in the exterior and interior columns, which results in sharp drop of strength compared with the behavior of the model with friction dampers.

In this paper a substantial modification of the model is proposed in order to enhance its capability in predicting the residual strength kinetics with emphasis to the "sudden drop" of strength before catastrophic failure.

However the major drop of strength occurs as a result of yield of the 4th story beam, and the residual strength is larger than that of the model SD. Figure 15 depicts the maximum inter-story drifts of the model structures at the point of the maximum strength and at the maximum inter-story drift of 2.5% obtained from pushover analysis.

The coefficient of thermal expansion (CTE), the corrosion resistance against high- temperature water vapor, and the drops of strength and elastic modulus after exposure for high-temperature water vapor were investigated.

As observed in the previous sections, the major strength drop of the strength-designed model SD occurs due to plastic hinges in the exterior columns whereas the other structures designed by capacity design process fail by concentration of plastic hinges in beams.

Further increasing lignin content from 25%to60%0% did not result in additional drop of the strength, but when lignin content was more than 60%, the compressive strength decreased again because too much lignin resulted in more irregular cellular structure and weakened the crosslinks, as shown in Figure 6.

But simultaneously, it would lead to a drop of mechanical strength of the corresponding copolymer membrane.

At very low MPS loading, e.g., 2 phr, enough numbers of polymer chains are not anchoring into the mesopores which effects in the drop of tensile strength.