Sentence examples for district heaters from inspiring English sources

It uses a typical German condensing temperature and a factor depending on the number of district heaters.

The influence of the steam extraction rate on the exergy destruction in the district heaters is part of [17].

The CHP plant with three district heaters is presented, but similar models were analyzed with one and two district heaters as well.7 This basic example is used to analyze the influence of the number of heating condensers but also shows the influence of the energetic losses (here referred to as flue gas losses) for CCPPs.

Second, in the models with two and three district heaters the pressure on the low pressure steam extraction is so low that the condensing temperature is only slightly above the district heating return flow temperature.

If only two district heaters are installed, the one with the highest extraction pressure is neglected and in case of one district heater only the intermediate one is considered.

A pressure control flap is installed in the overflow steam line from the IP to the LP turbine, which is often used to control the condensing temperature in the district heaters.

Therefore, only a small amount of steam is fed to the first district heater.

The steep drop is due to a load shift from the first to the second district heater, if the heat extraction is increased from 160 to 225 MW.

If the steam extraction for the high-pressure district heater could have been increased, the heat extraction and the power loss would have been higher.

The success of the bioenergy village project is dependent on the majority of the village households deciding to get their heating energy from the district heater via the pipeline.

However, the installation of multiple heating exchangers offers the opportunity to satisfy low-temperature heat demands only with the low pressure district heater(s), so that no steam has to be extracted from one of the high pressure extractions for this purpose.