An alternative method is based on adaptive weights corresponding to colour and distance of the supporting pixels to the anchor pixel.
In addition, the gap distance of the two support jaws of the three-point bending pliers was reduced to 7 mm instead of 17 mm as in the Otto et al. (1995) device.
For a fixed time, the result in question proves that the mechanical and thermal effects are controlled by an exponential decay estimate in terms of the square of the distance from the support of the external given data.
Effect of distance from the support on the penetration mechanism of clamped circular polycarbonate armor plates.
It says that the distance below 1 of the support-strength of C for (B⊃A) equals the product of the distance below 1 of the support strength of (B·C) for A and the support strength of C for B. This makes good sense: the support of C for (B⊃A) (i.e., for (~B∨A)) is closer to 1 than the support of (B·C) for A by the multiplicative factor Pα[B | C], which reflects the degree to which C supports ~B.
The shear force, (TS), due to external load at a distance (x) from the left end of the lower steel plate is: {text{TS}} =, p., left( {, a, +, x{text{ l}}_{text{co}} / 2} right), (37 where (a) is the distance from the support of the nearer end of the lower steel plate.
These increases were larger for the obese patients than for the control group suggesting that for the control group, postural CoP oscillations were relatively limited and maximal CoP excursions remained at distance of the base of support borderline in comparison to the obese patients.
The plated alloy layers adhered well to Cu Zn brass and steel, were of thickness from a fraction to tens of micrometers and the molybdenum content was independent of the distance from the support.
From the conducted investigations it has been evidenced that an optimal distance of the panel from the support can be found, corresponding to which the efficiency is maximized.
It was observed that with the increase in distance of the notch from the support, the load carrying capacity of notched I-joists can even decrease up to 80% in comparison with the uncut I-joists.
