For BRBs' design and implementation in EDSs, these analytical results can help predict a regime of relative end-displacements representative of the BRB's demands, when the bridge is subjected to both earthquake and temperature change in the superstructure.
Thus, additional experimental tests are needed to be performed by imposing displacement paths representative of the displacements actually imposed by earthquakes.
If either sEMG signal was above baseline then that trial was discarded ensuring that all measures (torque and angular displacement) were representative of the passive application of force through the ankle by the primary investigator.
Initial scoping calculations on the latter suggested that the rate at which LNAPL is able to migrate from a waste package is likely to be very small and insignificant for likely representative displacement pressure data: this represents a key result.
Open dots show the representative displacement at each sub-strand.
(b), (c) Evolution of the coefficient of friction with shear displacement for two representative samples: U1381A-6R-2 W (UnIt I) and U1381A-8R-1 W (UnII II). Figure 4a shows the initial peak and steady-state μ values measured for all the samples.
Local 3-D stress, strain and displacement fields for representative sections in the component-bars are recovered, based on the stress resultants from the 1-D global beam analysis.
With the material parameters calibrated, we show that the aforementioned constitutive model is able to accurately predict the force vs. displacement responses of representative experiments conducted under multi-axial stress-states at temperatures within the supercooled liquid region, namely three-point bending and the superplastic forming of a miniature gear component.
Column displacement experiments of several representative compounds showed that the identified displacers were efficacious in the displacement of single component and binary mixtures.
Therefore, the maximum displacements of the two representative trusses in the X and Y directions can be estimated as: δ x = δ C x + δ T x + δ S x and δ y = δ C y + δ T y + δ S y. (24).
Below are two histograms showing the distribution of bead displacements pooled from 5 representative, independent cell clusters on 8kPa and 35kPa substrates, respectively.
