Sentence examples for displacement pattern for from inspiring English sources

The typical displacement pattern for C H stretching mode shows a random displacement of H atoms in contrast to C atoms.

We analyzed the atomic displacements for different low-frequency Raman peaks predicted for eGNR by the DFT simulations, and found that the RBM-like mode for this ribbon should appear at 149.45 cm−1 (Fig. 2c); the actual displacement pattern for this vibration is shown in Fig. 2d.

The combinations of in-plane and out-of-plane displacement patterns for which Coriolis coupling is present are investigated and the corresponding natural frequencies and mode shapes of the rotating ring are derived.

The displacement pattern seen for whole of the craniofacial region is pyramidal in shape with the base in the inferior region and the apex at the superior region.

Our research objective was to develop a quantitative method for assessing displacement patterns of the gel liner during walking for patients with transtibial amputation.

Storey forces or shears are no longer applied directly to the structure but rather come as a result of structural equilibrium to the applied displacement pattern, thus allowing for the reproduction of reversal of storey shear distributions.

Fig. 5 Displacement pattern in the X-axis for the a conventional HYRAX expander and b bone-borne HYRAX expander (a1, b1, non-cleft side; a2, b2, cleft side; a3, b3, frontal view; a4, b4, left palatal slope; a5, b5, right palatal slope; and a6, b6, mid-palatal area).

Fig. 6 Displacement pattern in the Y-axis for the a conventional HYRAX expander and b bone-borne HYRAX expander (a1, b1, non-cleft side; a2, b2, cleft side; a3, b3, frontal view; a4, b4, left palatal slope; a5, b5, right palatal slope; and a6, b6, mid-palatal area).

Fig. 7 Displacement pattern in the Z-axis for the a conventional HYRAX expander and b bone-borne HYRAX expander (a1, b1, non-cleft side; a2, b2, cleft side; a3, b3, frontal view; a4, b4, left palatal slope; a5, b5, right palatal slope; and a6, b6, mid-palatal area).

The displacement pattern at the different suture sites for implant-supported RME and the standard RME is depicted in Table 2.

For both time periods, the horizontal displacement pattern calculated from our optimum model (solid red lines) shows a good agreement with the observed displacement (black and white circles), especially further than 35 km from the epicenter.