Due to the equilibrium displacement, hence, Delta t_{text{i}} = Delta t. (30).
Shallow fault slip is essential to produce the observed ground displacement; hence, the link to the M j 5.8 event seems unlikely but cannot be rejected entirely.
We also analyzed the ATM response using a Lissajous plot, displaying the instantaneous sound pressure against instantaneous displacement, hence revealing the phase of the force applied by the active mechanism.
Case studies show how the introduction of a PI-controller for the top tension affects the horizontal displacement, and hence may prevent collision between the risers.
In conclusion, the injection water, in alternating slugs or simultaneously with gas forms, yields a more stable displacement front, hence better project profitability over other CO2-injection modes.
Another group looked at the differences between uniaxial and polyaxial screws in locking plates using calcaneal saw bones and found that during cyclical loading the plate with the polyaxial screws showed less displacement and hence increased stability [44].
Introducing further the notation as, we calculate by the following scheme with either a forward or backward difference with regard to τ zz as: (2 This scheme satisfies the boundary conditions on the crack planes as described in Appendix A. Note that Eq. (1b) requires the continuity of the displacement and, hence, it is only applicable to media without cracks.
The inevitable consequence of demands for ever greater speed, striking power, and endurance meant that displacement, and hence cost, of dreadnoughts tended to increase.
Control and kermit2 injected cells show similar average migratory velocities and radial displacements, while cells expressing the dominant negative kermit2mut show very little displacement and hence low velocities (Figure 7E, F).
A large spacing of control points allows modeling of global deformation with large displacement, and hence, one control point will influence the deformation of large local areas, while a small spacing of control points allows modeling of local deformation within small areas.
The EM exhibit a nonlinear force-current-displacement behaviour, hence to design a linear controller, the total range for displacement of PFB at the levitated end is restricted to a small gap around the equilibrium position.
