Sentence examples for displacement control to from inspiring English sources

The pullout test was conducted with displacement control to obtain hysteretic pullout behavior by four cycling loadings.

In this transmission, the rotor speed can be regulated by hydraulic pump displacement control to realize the MPPT, and the power can be stabilized through the hydraulic system.

The frame specimens were quasi-statically pushed downward at the top of center column under displacement control to investigate the progressive collapse mechanism of the RC frames, with a focus on the effects of infill walls.

For instance Fig. 15 shows the torque-to-moment ratios (T/M) for the applied load on Column 4-R and Column 4. The torque-to-moment ratio of Column 4 reduced significantly after shifting from load control to displacement control at a lower load level compared to Column 4-R.

Based upon the incremental theory, a modified initial stress method is introduced associated with displacement control technique to deal with the strain-softening problem.

The nonlinear governing equations are solved using Newton Raphson iterative technique coupled with the adaptive displacement control method to efficiently trace the equilibrium path.

For that purpose, an experimental program was carried out with twelve slabs monotonically tested under displacement control up to failure by using a four-point bending test configuration.

Thus, the global nonlinear equilibrium equations of the structure at the macroscopic level can be solved by using the general displacement control algorithm to capture the equilibrium path with multiple critical points.

The nonlinear governing equations, considering geometric nonlinearity based on von Karman's assumption for moderately large deformation, are solved using Newton Raphson iteration procedure coupled with displacement control method to trace the pre-buckling/post-buckling equilibrium path.

Three femurs were tested to failure under torsion, with displacement control at a rate of 0.25° per second.

Axial loads were applied to the cup with the femoral prosthesis under displacement control at 1 mm/sec until failure.