Sentence examples for displacement at constant from inspiring English sources
Load displacement curve of the joint by considering material nonlinearity revealed of 3.66% and 3.97% more displacement at constant force in comparison to the linear case of three and five bolted joints, respectively.
Though Equation 1 strictly applies only to steady-state behaviour, many friction experiments generally show some degree of slip hardening (increasing μ with displacement at constant velocity) due to effects such as gouge extrusion (Den Hartog et al. 2012a).
At the second run, one load-to-failure test was performed in which the actuator forced a continuous uninterrupted vertical distal ulnar displacement at constant velocity.
In all experiments, the applied normal stress was 10 ± 0.1 MPa during sliding, and sample were sheared up to 10 mm displacement at a constant velocity of 3 µm/s.
I do have a sense of displacement as constant instability — the uninterrupted existence of everything that I love and care about is not guaranteed at all.
Cantilever bending fatigue tests conducted at different relative humidity levels at constant displacement amplitude revealed increased fatigue life for polyamide 6 nanocomposites at high humidity.
The brain showed average relaxation of 74% from its peak force during loading to an approximately asymptotic force over a 5 minute hold at constant displacement.
More than 40 pullout tests have been performed, at constant displacement rate, on three different HDPE extruded geogrids embedded in a compacted granular soil by varying the specimen lengths and the applied vertical effective pressures.
An initial load of 1 N was applied, followed by constant displacement at a strain rate of 0.9 mm/min until implant failure.
Roosta et al. (2006) developed a visco-plastic multilaminate model to model the shear stress-shear displacement and normal displacement shear displace of artificial joint specimen at constant normal load conditions.
After the experiments, the extent of compression-shear and tension-shear based failure modes were characterized at constant punch displacements of 8 and 10 mm for SPR = 2 and 5, respectively.
