Sentence examples for dispense device from inspiring English sources

In this study, we have developed a system of HRM analysis as follows: cost-cutting with fluorescent intercalator; SYTO 9, introduction of the nested PCR for precision enhancement and avoidance of variability, speed-up with 384 samples treatment in a single experiment, and high uniformity of dispensed volume and removal of human error by using the automatic dispense device.

Using high-speed videography, individual diameters were measured in droplet bursts, which indicated that the first several droplets emerging from a dispense device may differ significantly in size from subsequent droplets.

With 5 mm of fluid in the weighing vessel, droplets were ejected from the dispense device at heights of 3 mm, 6 mm, and 9 mm from the fluid.

The incongruity has been explained as an approach to steady-state acoustic resonances within the dispense device, as well as the establishment of fluid resonances at the meniscus and wetting of the orifice.

Typically, a 50 ng droplet emerges from the dispense device with a velocity between 2 and 3 m/s, and after about 10 mm decelerates by air resistance to less than 0.5 m/s before impacting and coalescing with the liquid at the bottom of the weighing vessel.

We set the fluidic head pressure to a value about 2 mbar lower than normal to induce a "first droplets" incongruity and programmed the dispense device to deliver 200 ten-drop bursts, each burst followed by a time delay of 1 s with the experiment repeated five times.

We anticipate use of these gravimetric methods will permit detailed study of operational and environmental factors that influence droplet mass during dispensing, facilitate calibration of high-sensitivity sensors such as quartz crystal microbalances, and enable the use of DOD dispense devices for the reliable production of trace standard materials.

At around the same time, Shepherd-Barron, workedrked for banknote manufacturer De La Rue, was developing a rival cash-dispensing device.

A model of the microfluidic droplet dispensing device was constructed based on the AutoCAD drawing used for device fabrication.

The droplet dispensing device had an integrated second nozzle to adjust the distance between the droplets generated in the first nozzle.

The treat-dispensing device called the Petcubes Bites 2 has been redesigned to be more compact, so it can better fit into smaller spaces.