Sentence examples for disk velocity from inspiring English sources

Spin coating technology, widely used in the production of thin and uniform layers on porous substrates was used here to fabricate in one coating step symmetric mixed matrix membranes (MMMs) by adjusting the spinning disk velocity, rotational time, and solid concentration and volume of solution.

The Da number was found to decrease significantly with disk angular velocity and at high disk angular velocities (ω>15 rpm), Da was much lower than 0.1, even when the concentration of the contaminant in the bulk was extremely small (i.e. 1 μmol/l).

In the range of 2 6 rpm the degradation rate increased almost linearly with disk angular velocity.

Above 6 rpm, however, the influence of disk angular velocity was not significant.

The results showed that the reaction rate increased with disk angular velocity in accordance with a saturation-type dependency.

The photocatalytic degradation of a model non-volatile chlorinated aromatic compound 4-chlorobenzoic acid (4-CBA) was investigated as a function of disk angular velocity, contaminant concentration, and incident light intensity using a rotating disk photocatalytic reactor (RDPR).

The effect of pH, organic ligand concentration and disk rotation velocity on the partial current density of chromium electroplating was demonstrated.

The initial increase in the reaction rate with disk angular velocity was attributed to the longer time available per rotation resulting in higher down flow of liquid carried by the disk and to the increase in the overall mass transfer coefficient.

In addition, the same problem has been solved by a semi-analytical procedure in which the disk surface velocity is numerically defined by a finite-element model and sound radiation is then analytically obtained using a modified circular radiator model.

With respect to the effect of these three parameters on the degradation rate, the obtained results suggested the absence of significant mass transfer limitations at disk angular velocities higher than 6 rpm.

If there is a grain-concentrated part in the disk, the relative velocity due to the lift force may dominate there because of the high collision rate.