Sentence examples for discrete combinations from inspiring English sources

The stress strain behavior of Fine Nevada sand is presented for discrete combinations of constant principal stress direction, α, and intermediate principal stress.

Through comparison of these five cell lines, we found that not only does each cell line express different numbers of miRNAs, they also employ discrete combinations of VEGF-related miRNAs (Table 5).

Finally, IFN-γ secretion from B cells was not detected in response to any single TLR or T-dependent stimulus, only following mitogenic stimulation with PMA and ionomycin or with discrete combinations of TLR agonists (see below).

DCEs can be used in surveys to elicit healthcare consumer preferences by describing a health state using discrete combinations of attributes and levels (McFadden 1974, Louviere et al. 2000, Amaya-Amaya et al. 2008, Batley 2008).

Similarly, the frequency with which discrete combinations of physical health problems occurred were similar for the first five most common comorbidity combinations among SMI and non-SMI patients, though differences appeared in the subsequent five combinations (Table  3).

Data summarising the combination of health conditions registered for each patient were collapsed separately by SMI status; frequencies of discrete combinations of conditions were generated and ordered from the most to least frequent.

Thus, although all 3 polyserum exhibit similar titers of anti-HER-2 antibodies by ELISA using native protein, it is clear that each polyserum is composed of a discrete combination of individual antibody specificities.

The error term ε e,i,j must be computed for every possible discrete combination of the relevant parameters, using the midpoint of each parameter bin, and the errors can then be converted to probabilities to fill in the joint probability table T e,i,j.

This problem is called a discrete convex combinations problem.

By replacing the continuous variable with discrete linear combinations in this approach, multiple latent competency group-specific developments could be modelled (von Davier et al. 2011).

As the optimisation problem contains a number of continuous (ply angles and thicknesses) and discrete (material combinations) design variables, a sequential solution procedure is devised in which the optimal variables are computed in different stages.