Sentence examples for disc samples from inspiring English sources

Figure 18 SEM of fired hydroxyapatite disc samples after immersion in SBF for 29 days.

This procedure made it possible to estimate total tree height at 150 of the 219 sites where disc samples had been collected at multiple heights up the stem.

SEM of processed green disc samples before and after the immersion in SBF for 14 days are shown in Figure 16.

The silicon substituted hydroxyapatite green and fired disc samples showed a release of silicon ion into the solution of SBF, as shown in Figures 14 and 15.

The powder obtained after 45 h of milling was mixed thoroughly with a 3% PVA and then uni-axially compacted in to disc samples.

Three point bending and compression experiments were performed on beam and circular disc samples respectively to determine the 'apparent' stress-strain curves in bending and compression.

Relative height of each disc sample was then calculated as disc height divided by predicted total tree height.

This involved using a compatible volume and taper function (Katz et al. 1984) along with data on the diameter and heights of each disc sampled from the tree.

Annealing of a mechanically polished disc sample to 600 °C for 14 h in UHV resulted in a fourfold surface enrichment of zirconium.

To overcome the problem of missing heights, total height was predicted for each tree using a compatible volume and taper function along with data on the diameter and heights of each disc sampled from the tree.

A strong influence of the supporting rod for the fluence distribution on the backside of the low symmetry samples, i.e. square and rectangle was observed, in contrast to no influence for the disc sample.