Sentence examples for direction of the sheet from inspiring English sources

For each specimen, length 70 mm was taken along rolling direction of the sheet.

Different types of specimen geometries were fabricated in different orientations with respect to the rolling direction of the sheet to reveal the anisotropic fracture response of the alloy.

The study of the elastoplastic response during uniaxial loading was performed along the rolling and the transverse direction of the sheet, considering the influence of the texture and the thermal stresses on the mechanical behaviour.

The model, when suitably numerically implemented and calibrated, is shown to accurately predict the anisotropic superelastic response of tension specimens which were cut along different directions to the rolling direction of the sheet.

Both the in-plane and out-of-plane deformation characteristics of the sheet material have been generated from the measured initial texture and the uniaxial tensile curve along the rolling direction of the sheet by employing a rate-dependent crystal plasticity model.

Make sure that you have followed all of the directions on the sheet that came with your kit.

The elastic properties measured are the Young's modulus and Poisson's ratio at 15° increments from the rolling direction of the sheets.

To check whether this assumption holds for the material investigated, the degree of anisotropy was assessed from flow characteristics in three directions of the sheet sample.

Experimental results of tensile testing at different strain rates and different directions of the sheet material were used to determine fundamental constitutive parameters for both steel alloys.

Furthermore, flow stress curves in three directions of the sheet metal were recorded in tension and compression, to describe the anisotropy of the material and to allow future models of shearing to conform to the experimental conditions and thus be validated against the measured shearing forces.

The 6-cycle specimens consisted of fine equiaxed and elongated grains parallel to the rolling direction (RD) and had a basal texture with a c-axis inclined 24° from the normal direction toward the transverse direction (TD) of the sheet.