Sentence examples for direction of length from inspiring English sources

where α represents the parallelepiped orientation angle, defined as the angle between the direction of length 3D dimension and x axis of the world referential of the scene.

The interface treated with silane coupling agent A-151, the interfacial micro cracks caused by the sampling process have narrowed and discontinuous in the direction of length.

This test development start from the idea that in some cases it could be advantageous to orientate the parcels differently, not in the direction of length but in the direction of width (Fig. 6), so with a 90° rotation.

Comparing the derivatives results with the base value phone-specific correlations, there are no inconsistencies in the direction of length change with severity of condition; in other words, for all overlapping significant correlations, no positive correlation in one study is negative in the other.

From their test results, placing concrete at the ends of the beams yielded better performance than when concrete was placed at the mid-length because of better fiber orientation to the direction of beam length at the maximum moment zone.

Compared to Fig. 62a, b shows that with the increase of the cable's prestress, there is a significant increase of prestress spread in the area along the cable length in the roadway's top coal and perpendicular to the direction of cable length.

In the case of the 90∘ yaw angle, the LES results show that the influence of the three-dimensional flow from the nose of the train on the time-averaged wake flow is limited to a region of a length of 3.5 train heights from the tip of the nose in the direction of the length of the train.

On each story of the towerlike structure, wooden beams and struts (a structural piece designed to resist pressure in the direction of its length) support a widely projected slanting roof, the struts ascending diagonally from the central structure to the edge of the tiled roof.

The induced stress along the direction of fracture length can be calculated by Hooke's law.

One crack is normal to the edge of the strip and the material properties vary along the direction of crack length.

The central cross-sectional distributions of the plots in Figure 4 are shown in Figure 5, where voltage distribution is along the central cross-sectional line in the direction of electrode length.