Sentence examples for dimensions of the sections from inspiring English sources

The Geometry page lets us specify the physical dimensions of the sections in our model, and how NEURON will compartmentalize the model (nseg).

Dimensions of the sections were selected to promote local buckling, and inhibit other forms of buckling, such as distortional and lateral-torsional buckling.

However, applying this method to embedded steel elements would face the difficulty that the shape and geometric dimensions of the section might seriously affect the strain measurements.

It is proved that the answer is negative when the dimension of the sections is greater than or equal to 4. For two- three-dimensional sections, both negative and positive answers are given depending on the orders of dual volumes involved, and certain cases remain open.

The exhaust system studied has more than 8 m long and the dimensions of the cross sections varies from 1.5 m × 1 m at the inlet section to 2.6 m × 2 m at the outlet section.

The dimensions of this section are consistent with a maximum of two to three intermediates simultaneously occupying the middle section.

The size of the model beam was scaled down using the aspect ratios of the section and length of a typical precast beam, AASHTO Type VI beam. Figure 1 provides the detailed dimensions of the cross-section of the AASHTO Type VI and scaled model beam.

There are several design equations available for calculating the torsional compliance and the maximum torsion stress of a rectangular cross-section beam, but most depend on the relative magnitude of the two dimensions of the cross-section (i.e., the thickness and the width).

Design variables are taken as the stacking sequences of laminate and the dimensions of the cross-section.

The unknown dimensions of the cross-section are determined which satisfy the design constraints and minimize the material costs.

The dimensions of the cross-section, the material constants, the restraints stiffness, and their locations, position of the member ends are taken as the design variables.