Sentence examples for dimension shaft from inspiring English sources

Open image in new window Fig. 1 Computational domain Table 1 Features of impeller Parameter Dimension Shaft diameter, D s 40 mm Eye diameter, D o 182 mm Hub diameter, D h 55 mm Inlet diameter, D 1 160 mm Inlet blade width, b 1 54 mm Outlet blade width, b 2 30 mm Inlet blade angle, β 1 17°, 23° and 28° Outlet blade angle, β 2 25°, 40° and 70° Blade number, z 7 Outlet diameter, D 2 365 mm.

And where high stresses are involved, greater shaft dimension is employed for such design.

Investigation of natural ventilation using shafts in tunnels has been receiving more attentions, however, analyses on how shaft dimension and amount influence the natural ventilation performance have rarely been addressed.

We flew through the low opening and entered a new dimension where a shaft of sunlight streaming through the cave entrance flooded the grotto with brilliant blue light.

– all approximately 0.9 mm in shaft dimension, were used and the distal ends of the brand-matched silicone infusion sleeves were set exactly 1.0 mm from the tips of the needles.

The spindle drive mechanism, drive motor, bearing types, and spindle shaft dimensions are selected based on the target applications.

It is aimed to obtain the optimal dimensions for gearbox shaft, gear and the optimal rolling bearing.

To our knowledge references about the proximal femoral dimensions including neck shaft angle, length and width of the femoral neck in the Indian literature are scarce.

At the end, the efficiency model is applied to two face-hobbed examples with similar overall dimensions, but different shaft offsets to investigate the influences of key operating and design parameters on the mechanical gear mesh power losses.

Concluding this section, main shaft dimensions are 11.8 mm in external diameter and 186.6 mm in length between the end of the rotating knob and the axis of the two arms, whose dimensions are of 99.4 × 5.5 × 8.0 mm, while the graspers and relative holding frames are 47.5 × 5.5 × 5.5 mm.

Shaft design involves consideration of the layout of features and components to be mounted on the shaft, specific dimensions and allowable tolerances, materials, deflection, frequency response, life, and manufacturing constraints.