Sentence examples for differences in the slopes from inspiring English sources

Whether the differences in the slopes of the line segments in an interaction plot are statistically significant depends on the experimental error.

Following evaluation of primer specificity, standard curves relating cell number to cycle threshold were prepared for each strain individually and in combination in yogurt mix, and no significant differences in the slopes were observed.

This study introduces and reports the repeatability of a novel three-dimensional (3D) analysis for computing pre- versus post-operative differences in the slopes of the V-V and F-E planes and the P-D level between the tibial component and the arthritic tibial joint line.

Pre-operative versus post-operative differences in the slopes of the varus-valgus and flexion-extension planes and the proximal-distal level between the tibia resection and the arthritic tibial joint line can reliably be measured using the three-dimensional models of the tibia and fibula.

The differences in the slopes of patients with a less pronounced degree of hyperparathyroidism compared with patients with a higher degree of hyperparathyroidism and to controls suggest that BUA of the calcaneus contains information on bone complementary to DXA measured at the same site.

The F-test was used to compare differences in the slopes derived for interevent interval and amplitude analysis.

The differences in the slope at the final read count between the different libraries was mostly due to a low final read count rather than differences in the fitted hyperbolic curves (Table 4).

The differences in longevity between species are the result primarily of differences in the rate of aging and are therefore expressed in differences in the slope of the Gompertz function.

In particular, differences in the slope of the current/potential curves were observed for small polarizations above or below the corrosion potential.

The effects of different tool positions of the ball end cutter tool during 5-axis machining were studied and differences in the slope of the tilt and lead angle compared.

When individuals are asked to determine the numbers of briefly presented visual items, differences in the slope accuracy are typically found between small versus large numbers [1], [2].