Sentence examples for differences in the rotational from inspiring English sources

If differences in the rotational position of the femur had an important effect on the measurement error of the HSA, it would reduce statistical precision in the relative risk estimate, resulting in wider confidence intervals and reduced statistical power, thus making it more difficult to detect a potential effect.

All three of the permutation tests resulted in a p-value of approximately 0, suggesting that there is a difference in the rotational symmetry for all three comparisons, as hypothesized.

There was no significant difference in the rotational stability of the three types of toric intraocular lenses.

The normalized TCSPC decays are distinct due to 0.2 ns difference in the rotational correlation times between species.

However, under lateral bending or extension with a preload, there was no difference in the rotational angle among all cage models.

A recent report on TKR showed a considerable difference in the rotational plane between the intraoperative CAS component position and postoperative CT measurements (van der Linden-van der Zwaag et al. 2011).

The difference in the rotational angle between before and after the shoulder motion was calculated after the arm was lowered via the most direct route (along the gray plane on the right model of Figure  2) to the initial position without rotation of the shoulder joint.

Furthermore, if we consider differences solely in the rotational correlation time, this difference should ideally affect the whole decay curve and not only a short segment as, for example, shown in Figure 7 A. In other words, if ρ(1) and ρ(2) ≪ τ, the two decays are nearly equal for any time t≫ ρ, no matter how different the two rotational correlation times are.

Following an i.p. injection of amphetamine, no statistically significant differences in the drug-induced rotational behavior could be detected between the treatment groups (one-way ANOVA, P = 0.211, F 4,22 = 1.628).

The study showed a remarkable difference in the spindle rotational speed stability against torque disturbance between a spindle system equipped with an induction servo motor and a permanent magnet synchronous servo motor.

After changing the stem connection from rigid to sliding, the reconstruction did not produce much more rotational migration than with the rigid connection; there were no statistically significant differences in any rotational migration observed between the reconstruction with a rigid stem connection and the reconstruction with a sliding stem connection (Table).