This disparity implies important differences in the fluctuation of hormone levels, VTG synthesis, and gonad maturation (Jensen et al. 2001).
Analysis of the data shows that there seems to be no distinct difference in the fluctuations with respect to steady-state and transient runs.
With the protease mutations, the largest orientational difference in the fluctuations is observed mostly at the proximity of residue 69 in the unprimed monomer and at residues 56, 78, 93 in both monomers in the slowest mode (Fig. 3A).
In the ANM analysis of the dynamics of the wild-type HIV-1 protease structures bound to its natural substrates, the highest orientational differences in the residue fluctuations and the largest extent of the asymmetry of the residue fluctuations in the two protease monomers were observed primarily along the hinge axes (Ozer et al. 2010).
Being related to dynamics and evolution, flexibility should also have impacts on structural divergence connected to the orientational difference in the fluctuation of the molecules.
The RMSF calculated for each residue (Fig. 6b) clearly shows a large difference in the fluctuation of the positions of the alpha carbons of the thumb domain residues when comparing the XynA domains in the chimeras in the presence and absence of xylose.
In related work, we have mapped out the free energy landscape of mononucleosomes (Fig. 2) and nucleosome arrays to investigate differences in the conformational fluctuations of nucleosomes in isolation and those present within arrays.
Results show only very slight changes in the mean flow induced by the plate, and no differences in the velocity fluctuation amplitudes on the jet centreline, suggesting that wave-packet models derived for jets without installation effects may be representative of the installed case, at least for the jet plate distances considered here.
Results Both the overall trends in mortality differences and the fluctuations in mortality for both men and women were better explained by period effects than by cohort effects.
Figure 9 shows that for either the aluminum or copper work piece, the variations of forces are independent on the thermostat layer, in spite of the minor difference in the force fluctuations.Figure 10 presents defect structures in single crystal aluminum (top row) and copper (bottom row) after nanometric cutting using MD models with and without thermostat layer.
