Sentence examples for differences between the machines from inspiring English sources

Audio signals processed on different machines or browsers may have slight differences due to hardware or software differences between the machines, while the same combination of machine and browser will produce the same output.

A graphical method, the Bland-Altman plot, was used to detect differences between the machines.

The minimal detectable flow velocities showed very large differences between the machines.

Before correction, the mean difference between the machines was 32µm for Spectralis™ vs. Cirrus™, 52µm for Cirrus™ vs. Stratus™, and 84µm for Spectralis™ vs. Stratus™.

This lack of a difference between the machines could be due in part to the fact that a higher percentage of filters with a smaller surface area were used with the more modern machines.

For the convenience of measuring the machining errors, the machining errors in z direction is the z coordinate difference between the machined workpiece surface and the machined nominal workpiece surface in each sample points under the workpiece coordinate as shown in Fig. 12 are defined.

The differences found between the machines are probably caused by fundamental differences in processing of the PD signal or internal settings inaccessible to users.

The very large differences found between the machines are only partly explained by each machine's Doppler frequency, lower limits of PRF and wall filter settings, but are most probably caused mainly by fundamental differences in processing the PD signal or internal settings inaccessible to users.

The saturated and capped group showed no difference in the effective moduli derived from different measurement methods, while the saturated and non-capped group showed a significant difference between the machine platen- and extensometer-derived moduli.

The distance is calculated first by measuring the difference between the machine assignment vectors ({rm{MA}}_{1}) and ({rm{MA}}_{2}) which is in order of O(n), then by verifying the execution order difference of the operation sequence vectors ({rm{OS}}_{1}) and ({rm{OS}}_{2}) which is in order of O(1).

Cross-calibration analysis reported no significant differences between the 2 machines [ 16].