However, there was a significant difference in the strength of the texture for different orientations that was absent for low strain rate deformed samples at high strain rate.
Thus, in contrast to the temporal coupling with slow oscillations, BZ and CZ neurons fired all spikes and LTS bursts at different phases of spindle oscillations, but there was no difference in the strength of their phase-locked firing.
The four samples show quite different dynamic relaxation spectra over wide frequency range, revealing large difference in the strength distribution of dynamic ionic bonds.
The size of standard coffee cups is larger in the United States compared with that in Europe or Japan, and the difference in the strength of coffee brew may compensate for the different serving size between countries[ 89].
This lack of agreement between comparisons using different data sets suggests that there may not be a sex difference in the strength of association between W→S fixation bias and recombination.
It sounds obvious, but levelling up your trainer experience will make a big difference in the strength of Pokémon you can capture.
This combination is antagonistic in both C. albicans and S. cerevisiae, but our analysis suggested enhanced selectivity for the growth of C. albicans due to a difference in the strength of antagonism (Supplementary Fig. 8).
There is no essential difference in reaction mechanism for two kinds of Bayer RM and the difference in the strength properties is essentially originates from the active material content.
Small-angle X-ray scattering has done to explore the difference in the strength of the thermal fluctuation effects between A B diblock copolymer and (A/2)2–B Y-shaped copolymer.
For the same aging temperature, the strength was increased with the cooling rate but the difference in the strength became smaller when the CuCrZr alloys were aged at above 580 °C.
Based on the test results, the 180° standard hook was the most efficient in terms of strength and ductility with a slight difference in the strength and 15% higher ductility than using the straight end detail.
