Sentence examples for difference between two signals from inspiring English sources
As cited above, and given a measurements made from an array of electrodes or sensors, phase synchronization methods are used to detect the phase difference between two signals from two different electrodes or sensors, this can be applied for source location.
The INSAMP is an instrumentation amplifier that allows amplifying the difference between two signals.
Such a full-reference IQA method is a kind of comparison that involves measuring the similarity or difference between two signals in a perceptually meaningful way.
The PSI among brain regions indicates connectivity in terms of the phase difference between two signals.
The above equation shows that the phase difference between two signals is equivalent to the cross-power spectrum.
When the discriminator spacing is greater than 0.5 chip and the critical point is in the vicinity of 2× spacing, the critical point has no effect on the carrier phase difference between two signals.
The accuracy of the timing, that is, the time difference between signals coming from the two different CHs, has to be smaller than the CP length of the OFDM system.
When the quality difference between two signal sources is too big, then the fusion result would be bad because the relatively worse signal may disturb the relatively better signal resembling the noise.
Another technique relied on the identification of the minimum of the average magnitude difference function (AMDF) between two signals, which was recently modified by joint consideration of the AMDF and the average magnitude sum function (AMSF) to improve the performance in reverberant environment [13].
The power difference between the spoofing signal and authentic signal, the carrier phase difference, and the code phase difference between the two signals are configured to generate the spoofing signal.
The GNSS signal simulation source can accurately control the navigation signal SNR, the spoofing-signal ratio of an authentic signal to a spoofing signal, the carrier phase difference, and the code phase difference between the two signals.
