The mean size of the ZnO CTS NPs synthesized through nano spray dying method ranged between 93.2 and 403 nm.
We employed the dying method of Coomassie brilliant blue G-250 to determine the protein concentration of algal samples, measuring the absorbency at the wavelength of 595 nm.
We also analyzed pollen viability of the C. aquatica HG using I2-KI dying method, and found that the pollen grains were sterile (Additional file 1: Table S3).
In addition, it has reduced the period for developing, debugging and reengineering of the LLD, compared to die traditional method that directly prepares an LLD.
Printed on both cotton denim and silk in a variety of colors, using an inexpensive dying method called discharge printing, it shows fish swimming in linear eddies of water and spray.
The mean yield pressure was calculated from Heckel's plots obtained with the in-die method.
So if you're as tired as we are of the same old egg-dying method, then we've got a few different easter ideas that can offer your batch some extra character.
The "in-die" method was used, and thus, the yield pressure during compression is considered to reflect the total deformation ability: Plastic and elastic deformation (24).
pressure is the tablet height at maximum pressure and h x is (1) for the "in-die" method the tablet height at force after the compression event of 0.05 kN or (2) the tablet height of the ejected tablet immediately after ejection, after 24 h, and after 1 week of storage under controlled conditions, respectively.
The paper discusses the differences between open and closed die forging methods, as applied to the range of nickel-based superalloys, from the relatively forgeable heat-resistant engineering alloys to the creep-resistant alloys used in turbine manufacture which have very poor hot-workability.
