Sentence examples for die and substrate from inspiring English sources

The paper emphasizes and discusses in details the assembly of a flip-chip package based on copper columns bumped die and substrate with stencil printed ICA deposits at sub-100 μm pitch.

The silicon die and substrate are bonded in a hydrogen environment at 140 °C.

The results show that die and substrate thicknesses are the most influential factors among the selected parameters on stress at the interface and on copper interconnects.

Using recently-developed Ag stress-migration bonding (SMB), a light-emitting diode (LED) die can be bonded on a glass substrate above 200 °C in air without pressure, where both the die and substrate surfaces are coated with a few-microns-thick Ag layer.

Though the authors occasionally lapse into jargon (their barnacles cling to "substrate" until the animals die and their six-plate shells "become disarticulated"), on the whole, their writing is plain and clear.

In the later stages of these blooms, senescent individuals detach from the substrate and can accumulate in large floating or benthic mats, which gradually die and decay, creating harmful anoxic conditions.

punch, die and blank holder.

It is based on a syringe type die-counter electrode set-up used for conventional continuous electrospinning, the key feature being a reduction of the distance between the spinning die and the substrate from the conventional value of 10 50 cm down to the millimeter and below mm range in order to suppress the onset of bending instabilities and the corresponding spread of the deposition area.

In contrast, most wild-type neurons died and detached from the substrate after exposure to 5 µM AβpE3 42 or a mixture of 5%% AβpE3 42 and 95%% Aβ1 42 (5 µM peptides in total).

The effects of slot die geometry, substrate geometry, and fluid properties on air entrainment in coatings have been extensively investigated by several researchers in the past.

This paper presents a duplex surface treatment approach for dissolution resistance that consists of nitrided hot working die steel substrate coated by multi-layer titanium-based coatings applied by the large area filtered arc deposition technique.