Sentence examples for diameters were estimated using from inspiring English sources

From the burn times, particle diameters were estimated using correlations reported in the literature.

The mean PSf fiber diameters were estimated using image analysis J software and calculated by selecting 100 fibers randomly observed on the SEM image.

Otherwise, the diameters were estimated using begin{aligned} D = {1130 over sqrt{p_R}} 10^{-H_R/5}, end{aligned} (1 where D is the diameter in km, (H_R) is the R band absolute magnitude, (p_R) is the R band geometric albedo, and the conversion constant of 1130 is from Jewitt et al.

The conducting filament diameter is estimated using a new method under a constant current stress of 80 μA (Figure 7).

In addition to the defect concentration obtained from the intensity ratio of the D/G band, from Raman spectroscopy, the CNT diameter was estimated using the splitting of the G− and G+ peaks [12].

In addition, endosteal diameter was estimated using the algorithm described by Thomas J. Beck [ 29].

Genetic parameters and genetic trends for staple length (SL), staple fineness (SF), fiber length (FL) and fiber diameter (FD) were estimated using 7798 repeat records of 4583 Inner Mongolia cashmere goats at different ages measured from 2008 2011.

Therefore, the threshold diameter and diameter of clinical detection were estimated using data from the Frequency Trial on the numbers of invasive breast cancers in both groups of the trial split out by tumour size and detection mode (see Appendix).

Pump pulse spot diameters of 250 360 μm were estimated using a micrometer stage and a razor blade; the broadband probe pulses were focused to ∼50 μm.

After evaluation, the number concentrations and the geometric mean diameters of NaCl aerosol particles were estimated using a method presented in Park, An, and Hwang (2007a) and were compared to scanning mobility particle sizer (SMPS) data.

Indoor concentrations of PM2.5 (particulate matter ≤ 2.5 μm in aerodynamic diameter) and CO (carbon monoxide) were estimated using the single-zone model used for IWA 11 2012 (ISO 2012).