Sentence examples for diameter of metallic from inspiring English sources

In addition, the diameter of metallic or nonmetallic functionalized iron oxide NPs is prone to tailoring, and the necessary diameter can be obtained by controlling the reduction and repeat times.

Absorption by rats of lead from large particles (180 250 µm diameter) of metallic lead is lower than from lead salts and biologically incorporated lead [22].

Studied microwires of Co56Fe8Ni10Si10B16, Co41.7Fe36.4Si10.1B11.8, Fe55Co23B11.8Si10.2, Fe16 Co60Si11B13, Fe72.75Co2.25B15Si10, and Fe70B15Si10C5 compositions of ferromagnetic nucleus have positive magnetostriction constant and diameters of metallic nucleus from 1.2 to 22 μm.

The fiber formed by PDME method tends to be round as the diameter of the metallic fiber decreases.

This novel system can effect a reduction in diameter of a metallic rod without the use of drawing dies by heating a localised area of the rod while a tensile load is applied along its longitudinal axis.

Moreover, the increase in diameter of the metallic core to increase the EMSE further aggravates the problem.

As shown in the inset, the average diameter of the metallic NPs distributed on graphene sheets is approximately 15 nm.

Nonetheless, if the diameter of the metallic spheres in our crystal structures can be chosen close to or smaller than the relevant skin depth of the corresponding metal, the EM wave can be transmitted by tunnelling through the structure.

Although the idea of utilizing CNT films as conducting materials is simple, controlling density, average tube length, tube diameter and mixture of metallic and semiconducting CNTs is still challenging.

By refining the (Cu, Ag)/(Ni, Co) and La/(Cu, Ag) ratios in the La Al–(Cu,Ag)–(Ni, Co) pseudo-quaternary alloy, the formation of 30 mm diameter of La65Al14(Cu5/6Ag1/6 11(Ni1/2Co1/2)10 bulk metallic glass (BMG) alloy is achieved using water quenching.

Precise gripping and positioning of metallic ball with diameter of 100 μm using fabricated OPPMGs was successfully done at a low actuating voltage of 7 V, without any adhesion problems between two jaws of gripper and the ball.