Sentence examples for device are calculated from inspiring English sources

The performance indicators GOR (defined as the ratio of the condensation heat of water produced relative to the heat input) and yield of the device are calculated from the measured temperatures and flow rates for different operating conditions.

The gain and threshold current of the optimized device are calculated using a 15-level self-consistent rate equation model, and are shown to represent substantial improvements over the figures obtained, using the same calculation method, for the recently reported room temperature GaAs/Al0.44Ga0.56As QCL of Page et al. (Appl. Phys. Lett. 78 (2001 35299).

The complete kinematics of the device is calculated.

The coloration efficiency (CE) of the device is calculated to be 154 cm2 C−1 at 645 nm.

The CE of the device is calculated to be 408.9 cm2 cm2.

The detection limit of this sensing device was calculated equal to 10 ppb.

The new transfer matrix of the measured device is calculated and the results fit surprisingly well with the experiments.

Furthermore, a nanofilament diameter of approximately 40 nm in the RRAM device was calculated using a new method.

And then 3 cylinder shape device model and 1 conical shape device model was suggested and the heat flux intensity on the device was calculated.

The number of GeNWs (N) incorporated in the device was calculated by the ratio of the saturation current (I s) of a single GeNW.

Then the electrical current of the device is calculated in the state (a) and (b), at different bias voltages, and presented in Table 1 and Fig. 2.