Sentence examples for deviation of thickness from inspiring English sources

Therefore, two approaches to estimate the remaining yield and tensile strength of corroded steel plates are proposed by considering the statistical parameters such as initial thickness, standard deviation of thickness etc., which represents the condition of corrosion surface.

However, when the standard deviation of thickness values recorded at each site is considered (Table 3) most depositional sites (valley floors and alluvial fan) have a more varied tephra cover than do the erosional sites (slope crests and planar hillslopes).

However, the WS2/SiO2/Si sample series had significantly non-linear thickness variation for thickness ranging between 1.4 and 4.3 ML, which coincided with the range where there was significant deviation of thickness-dependent CA for very thin films, i.e., d WO3 < 3 nm.

Table 5 summarises the number of records, mean thickness and the standard deviation of the thickness for the Western Finisterres, Ohanopecosh and Kodiak sites.

To establish the Korean normative dataset of peripapillary RNFL thickness for each decade of age, the mean and standard deviation of RNFL thickness were calculated for each scanned sector.

The deviation of film thickness distribution decreased with a decrease in target moving step.

The developed dynamic models are then used as the basis for the design of a model predictive control algorithm that includes penalty on the deviation of film thickness, surface roughness and film porosity from their respective set-point values.

When target stay time was proportional to the target scanning area at the rotating substrate and target moving step was 5 mm, the relative deviation of film thickness distribution was less than 5% within a diameter of Φ 300 mm.

It is found that the relative deviation of film thickness distribution is less than 3% within a diameter of Φ 100 mm when the ratio of the rotation speed to revolution speed is 5.3 and the results show good agreement with experimental ones.

The standard deviation of the thickness is less than 2%% of the target value.

Ellipsometry studies of the thin films of collagen show that the preparations generated from the 0.4 mg/mL native collagen solution have an average thickness of 40 nm while those prepared from the lower solution of collagen (0.025 mg/mL) are 6 nm on average with a standard deviation of film thickness of less than 10% for both preparations.