Sentence examples for development of the specimen from inspiring English sources

The result is a sequence of photorealistic artificial images that show the development of the specimen within the interval between observations.

By analyzing the loading, deflection, strain and fracture development of the specimen in the process, studying the mechanical characteristics and failure pattern of such components.

However, the failure mode is not the shear failure in the equivalent shear zone; the experimental data still can be used to investigate the shear crack development of the specimen of 6H70. Figure 8 shows the crack development and failure in the right side of the specimen of 6H70, respectively.

Open image in new window Fig. 4 Crack development of the specimens (175R70, 200R70, 275R70 and 325R70).

The compression test is an important test to determine the strength development of the concrete specimens (Hameed et al. 2012).

The influence of the parameters on the failure mode, load versus deformation relationship, axial compressive strength, and strain development of the tested specimens were investigated.

Based on the crack development of each specimen, the average ratio of the residual total shear crack widths to the residual maximum shear crack width for the HSRC beam specimens is approximately 4.5.

At the microscopic scale, the development of the microcracks on the specimen surfaces increases up to ∼1000 cracks/mm2 with the compression up to the ultimate fracture stress of ∼2200 MPa.

(1) Shear failure Taking the specimens of 175R70, 200R70, 275R70 and 325R70 for examples (Figs. 3 and 4; cracking point, maximum strength point and degradation point in Fig. 3 are recorded in the experiment), the crack development of each specimen is described as follows.

It contributes to the refinement of pores structure via the increasing geopolymer gel growth, as observed in the consistent compressive strength development of ambient-cured specimen to the oven-cured specimen.

The volume fraction of the light-colored bands was defined as the area ratio of white pixels, and was regarded as the degree of development of the flow structure for the specimen.