The cone penetration resistance was determined at the depths of 5, 10 and 15 cm while the soil moisture and suction relationship was determined on the surface (0 15 cm) soil at the suction of 4.5, 50, 100 and 150 kPa.
Figures 5(a)- 5(b) show the orientation distribution functions (ODFs, f as determined at each depth of the hip and knee samples. The angle β represents orientation of individual molecular chains with respect to the mean preferential orientation (θ p ).
No post-imaging treatment was used except for TOPRO-3 images which were systematically despeckled in Image J. CA 19-9 ALDH1LDH1 positive and negative cells within a spheroid were manually counted using the Cell Counter plug-in of the ImageJ software and the percentage of positive cells was determined at a depth of 40 μm and 70 μm relative to the coverslip.
The CMT solution was affected and the source was determined at a shallow depth south of and close to this station (Fig. 3a, b).
The stress magnitudes at the site of UEN were estimated by the HFT at only one depth, 347 m, while they are determined at two depths (340 and 399 m) by the DRA in this study.
The optimal configuration is determined at each construction depth for the EGS from 3000 down to 10,000 m and at each district heating network installed capacity from 0 to 60 MWth.
Employing the X-ray diffraction technique, the residual stresses were measured in the coating before and after micro-blasting and the related stress changes were determined at a certain depth from the film surface.
On the other hand, in the northern region, although the model temperatures determined at tectonic tremor depth vary from 250°C to 500°C in response to variations in the value of λ for the scenarios set to a convergence rate of 6 cm/year, higher temperature model (i.e., lower λ model) is appropriate in the light of the observed higher heat flow at onshore coastal region.
Also, the FT range was 2.8 15.4 mm (Table 1), so the ROI for EI was not determined at a constant depth.
The exposure time required to induce local necrosis was determined at different depths using thermocouples.
