Sentence examples similar to determination of slip from inspiring English sources

The application of LE-based metypicallyically results in determination of a slip surface corresponding to the lowest attained Safety Factor (SF), known as the Factor of Safety (Fs); however, it yields little information about reinforcement loading or connection load.

The isotropic hardening contribution follows from the evolution of statistically stored dislocation (SSD) densities during plastic deformation, where the determination of the slip resistance is based on the mutual short range interactions between all dislocation types, i.e. including the geometrically necessary dislocation (GND) densities.

The above section analytically and numerically shows the effect of pseudorange errors on the determination of cycle slips.

The testing technique allows measurement of free end slip as well as indirect determination of the strand slip at different cross sections of a member without interfering with bond phenomena.

But, as technology evolved, the determination of man to slip his earthbound shackles became less an inchoate religious yearning and more a plausible reality: it is difficult to tell whether the Chinese legend of the emperor Shun, who, in 2230 B.C., is said to have used a pair of conical reed hats to parachute to safety from the top of a burning granary, is folklore or history.

The nearly precise replication of the stress strain relation using at least two curve-fits for aluminum and its alloys validates the quantitative determination of the mean slip distance.

The pull-out test is a common experimental procedure for determination of the bond-slip law.

Load-displacement data from displacement hold tests, in both experiment and simulation, have enabled determination of the rate-dependent slip rule within the crystal plasticity model.

The calculation of the local slip velocities and the interface traction, together with the determination of the extent and location of slip zones, which are unknown before the solution of the problem, are discussed.

Determination of the peak temperature during slip is crucial to identify the faulting mechanism during an earthquake, because thermal pressurization (as well as melt lubrication) is promoted by frictional heating on the fault.

This research study has been performed using 136 FRP-to-timber joints subjected to pull-out tests, and accordingly a new predictive model for determination of the strain distribution profile, slip profile and shear stress along the interface has been established.