Sentence examples for determination of external from inspiring English sources

This paper presents an analytical algorithm of measuring six-dimensional F/T based on the screw theory for accurate determination of external forces during alignment.

We defined two ways for determination of external PEEP setting—(1) PEEP necessary to obtain a positive expiratory TPP and (2) PEEP necessary to obtain a plateau pressure between 28 and 30 cm H2O (maximal alveolar recruitment Express strategy).

Capacity determination of external shear keys presented in that study has been adopted, and nonlinear external shear key response is modeled using a combination of link elements as shown in Figure 8 to simulate the entire hysteretic response using SAP2000.

This work aims to partially compensate this lack of knowledge through the determination of external effective dose rates at different zones in the process at a typical plant located in the southwest of Spain.

The chapter highlights the structural design of air-cushion vehicle (ACV /surface effect ship (SES), and provides a brief introduction to the determination of external forces acting on hovercraft and the safety factors during the calculation of internal stresses.

This paper presents an optimization-based inverse procedure for the determination of external loads applied to a given mechanical structure, by using information concerning the dynamic behavior of the system and its corresponding finite element model.

This paper deals with determination of the external pressure coefficients on the new planned high-rise building with atypical cross-section.

Although an LAC of 0.1 cm−1 was manually applied to the phantom data to simulate the value applied to the heart by the MRAC segmentation, method AC3 is valid only for this phantom setup as the effects of segmentation and LAC determination of structures external to the phantom (such as non-cardiac tissues in a clinical scenario) were not investigated in this work.

The method allows the determination of the external mass transfer coefficient in the reactor, which is a major advantage when compared to the previous methods that require mimicking hydrodynamics of the reactor in a flow chamber or in a separate vessel.

For determination of the external exposition of PS residues, staining with Annexin-V-FITC and propidium iodide was used according to the manufacturer's instructions (#V13242, FITC Annexin V/Dead Cell Apoptosis kit, Invitrogen).

Hart performed morphometric determinations of the external diameter and wall thickness of intraparenchymal arterioles two hours after blood was injected into the cisterna magna of cats and observed a decreased external arteriolar diameter accompanied by an increased wall thickness.