Sentence examples for detection variables from inspiring English sources

The two primary signal detection variables of interest were sensitivity (the ability to discriminate visual signals from visual noise) and response bias (the tendency to report the presence of a signal, regardless of whether one is present).

Similar to text, there were also no significant correlations between year and number of images on risk factor or early detection variables.

No significant relationships between year and any of the risk factor or early detection variables in article text were found; in contrast, significant patterns of coverage over time were detected for three UV behavior variables.

The mean and variance of the detection variable in an array system consisting of antenna elements are expressed as (5).

The mean and variance of the detection variable increase linearly in accordance with the number of antenna elements, as shown in (5).

The structure of the ranging channel receiver shown in Figure 1 provides a diversity gain in both ranging code detection and propagation delay estimation because the detection variable is obtained through a noncoherent combination at each antenna path.

The detection variable of the array antenna system consisting of antenna elements is consequently a noncentral, chi-square distributed random variable with degrees of freedom, and can be written as (4).

The 13C NMR spectra and the DEPT (distortionless enhancement by polarization transfer) [20] spectra were recorded with a two channel 10 mm broadband, direct detection, variable temperature probe with proton decoupling and 2H lock at 76.773 MHz.

The received signal shown in (3) is a complex Gaussian random process with a mean of, which implies that the detection variable obtained at each antenna channel,, is a noncentral chi-square random process with two degrees of freedom.

With the use of the nitrogen pre-cooler, heater coil, and the variable temperature controller, the temperature was stable at 294.3 × 0.1 K. 13C NMR spectra were recorded with 22,000 acquisitions, 10 s recycle delay, 9 ms pulse width (70°) and 33 kHz sweep width using a two channel 10 mm broadband, direct detection, variable temperature probe with proton decoupling and 2H lock at 76.773 MHz.

These processes include: missing data treatment outlier detection variable redundancy detection variable transformation (recodes, creation of indicators, etc) The data preparation process must be conducted in close conjunction with the expert in order not to make false assumptions that can bias final results [ 30].