Sentence examples for designed using conventional from inspiring English sources

In addition, structures equipped with an inerter system and designed using conventional methods are potentially unsafe.

This benchmark model was extended by new appendices and a reference propeller, and designed using conventional design methods.

In particular, if the quantizers are designed using conventional open-loop source-coding strategies, it cannot be guaranteed that the overall system will be stable, when used in closed-loop control.

Using massively parallel sequencing data from degraded body fluids, we designed primers to amplify transcript regions of high read coverage, hence, higher stability, and compared these with primers designed using conventional methodology.

Both experimental and analytical studies are presented and it is concluded that FRP/GFRC thin structural elements can be designed using conventional techniques requiring only the use of appropriate material characteristics.

Theoretical results described in this paper indicate a significant improvements in both entrainment ratio (Rm), and pressure lift ratio (PDE/Ps), above those achievable from jet-pumps designed using conventional methods.

Several examples of tunnel structural design using conventional stability analysis and deterministic design procedures can be found in Rasouli (2009) and Dehghan et al. (2012).

The procedure gives structural information of the column, and therefore iterative computation encountered in the design using conventional procedure and commercial packages can be eliminated.

The procedure gives the structural information of the column, and therefore iterative computation encountered in the design using conventional procedure or commercial packages can be eliminated.

In knee simulator testing for normal gait and stair climbing, measured wear rates for X3 polyethylene were reduced by 79%and77%7% when compared to the same knee design using conventional polyethylene.

The paper also reports the results of a series of case studies that can be used by design engineers to benchmark-test FEM models proposed for MAW projects that are too complicated for analysis and design using conventional simple strength-based internal stability methods and where performance-based design requires estimates of wall deformations.