We demonstrated that this approach could be used to design conductivity sensing systems to be fit into the typical dimensions of the standard instrumentation for hemodialysis.
Plastics also are electrical insulators unless especially designed for conductivity.
This partial-contact effect is excluded by an optimally designed crack-conductivity-insensitive depth characterization signal function (DCSF), and consequently the master curves obtained from electric-discharge machining (EDM) notches can be utilized directly in the depth sizing of SCCs.
Electrical conductivity of select liquid foods and salt solutions was measured in situ during high pressure processing using a specially designed parallel electrode conductivity cell.
This article is focused on heat flow control within a composite material that has designed anisotropic thermal conductivity.
Two-probe electrochemical cells were designed for proton conductivity evaluation in the X, Y and Z directions using electrochemical impedance spectroscopy (EIS).
Nanofluids with concentrations of SnO2 nanoparticles up to 25% in weight fraction were designed for thermal conductivity and rheological studies while density behaviour were analysed up to 5% at pressures up to 45 MPa.
Electrical conductivity of gel samples was measured using the Keithley 2614B sourcemeter and a custom-designed conductivity cell lined with aluminum electrodes spaced at 1 cm apart.
A pilot program using specifically designed 'through-ice' conductivity-temperature-depth (CTD) and acoustic Doppler current profiling (ADCP) systems was conducted to opportunistically measure water mass properties and ocean currents at major ice stations.
Setup was designed for four probe conductivity measurements which can be used for two probes conductivity measurements also, depending upon the requirements under investigation.
