A conventional power analysis requires the designation of parameters such as the anticipated variability of individual measurements for all genes within each biological group, the total sample size (n, n1 & n2), the magnitude of the effect to be detected and the acceptable false positive rate (significance level α).
Table 10 Process parameters with their ranges and values at three levels Parameter designation Process parameters Range Level 1 Level 2 Level 3 A Total alkalinity (g/l) 40 to 80 40 70 80 B Temperature (°C) 45 to 75456075 75 C Rinsing water (pH) 5.5 to 8.5 5.5 6.5 8.5 D Timing (min) 0 to 25 5 15 25 Table 11 Washing defect values and S/N ratio against trial numbers Trial no.
Table 1 Process parameters with their ranges and values at three levels Parameter designation Process parameters Range Level 1 Level 2 Level 3 A Flowability (s) 15 to 25 15 20 25 B Coating thickness (μm) 20 to 50 20 40 50 C Pointage 6 to 12 6 8 12 D Temperature (°C) 20 to 50 2 35050.
The new method only requires the designation of relatively broad parameter ranges as an initial setting, while the conventional algorithm requires the identification of feasible initial parameters.
This research presents a novel parameters coupling designation method of diesel free-piston linear alternator.
In this paper, parameters of designation were studied to find the impact of affecting temperature gradient over the stack and the desired resonator diameter as a function of temperature gradient and mean pressure when it is prime mover.
It is simple to demonstrate the exact same behavior for the GY family of models, again because of the incorrect designation of nucleotide frequency parameters in the rate matrix as equal to empirical nucleotide frequencies.
Table 1 Test specimens' designations and test parameters.
Present support theories contain a number of shortcomings in the designation of fractured roof bolt parameters of rectangular or trapezoidal coal roadways.
Blast design and geotechnical parameters, such as linear charge concentration, burden, stemming length, specific charge, unconfined compressive strength (UCS), and rock quality designation (RQD), have been selected as input parameters and flyrock distance used as output parameter.
In addition, rock mass parameters including rock quality designation (RQD), uniaxial compressive strength (UCS), joint roughness coefficient (JRC) and Schmidt number (RN) show close relationship with P-wave velocity.
