Sentence examples for designated measurement from inspiring English sources

Other landmarks (designated "measurement points") were measured and located at the intersections of the wing pattern and wing veins on the O. excavata wing (19 landmarks; Additional file 1a, lower wing) and the T. juno wing (16 landmarks; Additional file 1b, lower wing).

The RSRP and RSRQ are measured by UEs during a designated measurement interval.

However, it was impossible to fix a designated TcB measurement time for each neonate in ordinary practice.

Plasma samples that were designated for measurement on the Orbitrap were depleted of 6 high abundance proteins as above and run in 3 separate lanes on a 1D-PAGE gel.

Based on grain development, five growth stages were designated for measurement: stage 1 (the end of anthesis) occurred on 30 April; stage 2 (milk-development stage) occurred on 8 May; stage 3 (the soft dough-development stage) occurred on 16 May; stage 4 (the hard dough-development stage) occurred on 24 May; and stage 5 (the ripening stage) occurred on 2 July.

We also calibrated PM2.5 measurements to account for the lower precision of the DustTrak (as compared to US EPA designated Federal Reference Method measurements) using the equation developed in Yanosky, et al. (2002) [ 18]: y = 0.33 x + 2.25 Where x equals recorded values and y equals corrected values.

While y 1 i, · indicates measurements in plasma, i.e. in the transfer compartment y1, y ˙ 7 i, · designates measurements of the excretion rate in the urine compartment y7.

The middle eight plants in the center double row were designated as the measurement plot.

The probe was immersed in the water at the designated locations, and measurements were recorded after 2 3 min; it was rinsed with fresh water between measurements and locations.

The partial COI sequence derived from the neotype (GenBank HM388349; BOLD EW-ECO-0533), and the physical description in Sims [8], which is identical in all but measurements to the designated neotype, and the measurements given here below are sufficient to ensure correct recognition of the specimen designated.

To increase an uncertain measurement exponentially, simply raise the measurement to the designated power, and then multiply the uncertainty by that power: To increase an uncertain measurement exponentially, simply raise the measurement to the designated power, and then multiply the uncertainty by that power: (2.0 cm ± 1.0 cm)3 =. (2.0 cm)3 ± (1.0 cm) x 3 =.