Sentence examples for design a fault from inspiring English sources

Several constructive approximation algorithms have be enproposed to design a fault tolerant network topology.

The methods proposed to deal with these problems are explained in detail and compared in order to design a fault detection and isolation method.

The purpose of this paper is to design a Fault Detection and Isolation (FDI) system based on LPV observers with application to a real wind turbine.

(4) where (r_{w}(t)) is the reference residual, and our objective is to design a fault detection filter (FDF) which can result in the minimal difference between the reference model and the fault detection filter.

In order to design a fault tolerant digital system, it is necessary to understand its behavior with the presence of faults in early design stage.

The inherent redundancy of balanced three-phase currents (voltages) is exploited to design a fault detection and isolation system for current (voltage) sensors.

Therefore, it is necessary to design a fault-tolerant (FT) control algorithm with an embedded fault diagnosis (FD) block.

The problem of reaching agreement in the distributed system is one of the most important areas of research to design a fault-tolerant system.

The main purpose is to design a fault-tolerant controller so as to make the resultant closed-loop system is stochastically synchronous in the presence of actuator failures.

The novelty is to design a fault-tolerant control (FTC) scheme for the overall system process where different faults may occur respectively at different time instants of the process, which is called the successional faulty case.

Based on this principle, by using an observer-based fault estimator with output feedback controllers and impulsive state feedback controllers, we design a fault-tolerant synchronization scheme, by which the synchronization can be eventually reached no matter whether there are faults, disturbances in the drive system or not.