Sentence examples for depth of defect from inspiring English sources

The dependence of the maximum depth of defect activation on the type of defect and on the energy of the ion was investigated for two typical values of the activation energy.

The results show that the estimated thermal diffusivities and the size and depth of defect are in good agreement with the reference values, and the relative deviations are less than 5%.

The depth of defect region extended to 263 nm (±12) with an effective diffusion length of 56.7 nm (±0.3).

Thirdly, the agreement of the diagnostic outcome was assessed in terms of area and depth of defect.

Calculation and experimental analysis have shown a good correlation between a cumulative damage factor (CDF) and depth of defects in cold-pilgered tubes.

In the present standard API 579/ASME FFS, the safety assessment of pipes with multiple local wall thinning defects is given, while as well as the influence of load condition, the influences of arrangement and relative depth of defects are ignored, which may influence the safety assessment considerably.

The lower value is more consistent with the simulated depth of defects calculated using TRIM program[10].

The presence of ERM was associated with the depth of lamellar defects; lamellar defects with ERM had an average defect depth of 205 (61) μm compared with 156 (44) μm of defects without ERM (t90 = 4.417, p<0.0001).

For different arrangements and relative depths of defects, based on a limit value 0.05 of the quantified index of the interaction between defects, a relatively systematic safety assessment of pipes with multiple local wall thinning defects under different load conditions has been proposed.

In this paper, the influence of the interaction between multiple local wall thinning defects on the remaining strength of pipes at different arrangements and depths of defects under different load conditions (pressure, tension-bending moment and compression-bending moment) are studied.

Finite element simulations were also performed to compare numerical depth of the defect with experiments and also to investigate the stress and strain states in the defect area.