Sentence examples for depositions I from inspiring English sources

On immunofluorescence, IgA, IgG, IgM as well as C1q and C3c depositions, i.e. a so-called fullhouse pattern, were detected in a mesangiocapillary pattern.

'I won't allow depositions,' 'I will allow depositions,' 'I'll only allow 15 minutes a witness.' You shouldn't put justice on a time clock".

"In all the testimony and the depositions I read, I didn't read anywhere where there was some unknown person walking into the locked area, walking into the supply room, pouring it with an accelerant, lighting it with an open flame and then walking out," Mr. Eaton said in the Tribune article.

Typical geographic settings include areas of active erosion or deposition (i.e., steep slopes or floodplains), areas of quartzite bedrock or quartz sand (i.e., major desert and dune regions), and wetlands.

Obtained results demonstrated that for several compounds, total deposition, i.e. the sum of wet and dry deposition, was marginally higher than wet deposition alone.

The films were synthesized using pulsed filtered cathodic arc and magnetron sputter deposition, i.e. techniques far from thermodynamic equilibrium.

This is because wetlands in agricultural landscapes can decrease sediment deposition, i.e., phosphorus and nitrogen, released as a result of cultivation and fertilization.

This advantage of larger membrane lungs, however, must be balanced against the possibility of low blood velocity increasing the incidence of thrombotic deposition, i.e., clotting [22].

The feasibility of a "one step deposition" (i.e. from one common solution bath) for Gd-doped ceria was demonstrated in the conditions presented in this paper.

The antibiotic dose placed in the nebulizer should take into account the significant extrapulmonary drug deposition (i.e., the residual antibiotic volume remaining in the nebulizer chamber, ventilator circuit and endotracheal tube deposition, and exhaled particles).

We show that Cu underpotential deposition does indeed take place, although the current peak representing underpotential deposition, i.e. the deposition of the first Cu monolayer, is shifted into the overpotential range for commonly employed sweep rates.