Sentence examples for deposition implies from inspiring English sources

In addition, the typical streak-like pattern observed throughout the deposition implies a layer-by-layer growth mode with high-quality crystallinity.

Catalytic chemical vapour deposition implies the catalytic conversion of a gaseous precursor into a solid material at the surface of reactive particles or of a continuous catalyst film acting as a template for the growing material.

Rapid variation of liquid fraction with top surface temperature during spray deposition implies that to maintain optimum conditions requires control of the temperature to within at least ±2°C.

For all samples, streaky or spotted RHEED patterns were observed after the Sr deposition, implying the epitaxial growth of Sr−Ge compounds.

In the present investigation, domain size growth, stacking fault annihilation and strain relaxation during low-temperature CuInSe2 co-evaporation are shown to correlate with Cu deposition, implying a driving force for grain growth induced by diffusion.

Reverse gradation and planar lamination of some deposits imply also direct deposition from bed load.

The results of this study identified potential candidate genes associated with chicken IMF deposition and imply that IMF deposition in chicken breast muscle is regulated and mediated not only by genes and pathways related to lipid metabolism and muscle development, but also by others involved in cell junctions.

The concave bank erosion and convex bank deposition processes imply that the point bar sand body is the thickest deposition body within the single meandering river belt.

These lower deposition rates imply that particles in the accumulation mode tend to remain in suspension for longer, and therefore travel longer distances.

Simulations suggested immigration of moths to lakeshore sites from the outbreak source was plausible on three of eight dates within the flight window, but the relatively narrow deposition footprints implied immigration occurred on different dates across lakeshore sites.

Prior to spraying, reducing the particle size (− 20 μm) and increasing the internal energy of the powders by the ball milling process resulted in no appreciable improvement in deposition efficiency, implying that sprayed particles still had insufficient ductility to plastically deform and flow.