Results for the dependence of spreading rate on time, drop mass, and alloy composition are compared with the predictions of a recently published model for diffusion-limited reactive wetting.
As summarized in Table 1, the contact area displayed 13-fold variation when the pMHC was varied, thus showing that cells efficiently discriminated between these TCR ligands within 20 min. The dependence of spreading on pMHC concentration was also studied: As shown in Figure 4, results allowed clear-cut discrimination between 2 groups of pMHCs.
Thus, the dose-dependence of spreading rate and area is clearly different between H74 and other peptides.
The dependence of the flame spread rate on phase change and thermal properties is investigated by varying three non-dimensional parameters, St, k̄l, and C̄Pl.
The general approach used in the present work suggests that the potential-dependence of the spreading rate of a two dimensional patch of crystal is more complex than was previously supposed.
A design methodology is developed to reveal the dependence of slow motion dynamics of spread mooring systems (SMS) on several design parameters, such as riser location, water depth, length and fairlead of mooring lines, orientation and pretension in the mooring lines.
For the all-to-all topology experiment, we again measured the group spread in dependence of several coupling factors.
The diagrams in Figure 7 shows the time to sync and the group spread in dependence of a different group size and coupling factor.
The simulation successfully reproduced some of the behavior observed in calibration data, showing the dependence of the bias and the spread of sphere diameter measurements on the studied beam patterns.
There may also be a spreading rate dependence of hydrogeologic properties, but we currently lack direct observations to test this hypothesis.
