Sentence examples for density performance from inspiring English sources
The results showed that the follower density performance measure was found to have the strongest correlations to platooning variables.
The result showed that the PDA-TFC membrane has higher flux, excellent power density performance and good stability.
In the present investigation, the influence of increased anode catalyst layer porosity on DFAFC power density performance is studied.
The effects of key operating parameters, such as temperature, gas composition and fuel utilization, on the voltage current density performance characteristic and thermoneutral voltage are then investigated.
Further presented are floating-gate transistor arrays (FGTAs), which enable reconfigurable CMOS static logic, achieving improved logic density, performance, and power consumption compared with LUT-based reconfigurable logic.
It was found that the most reasonable modification conditions to obtain the high power density performance are 0.2 g/l DA concentration with 1 h coating time.
Moreover, the GO/NiAl-LDHs material was utilized as the cathode in asymmetric supercapacitor, with excellent energy density and power density performances as well as excellent electrochemical stability.
In addition, our TFC membranes were able to capture 65 81% of theoretical maximum power density performances in comparison to only 50% of the more compactable commercial FO membrane.
Lynne Ramsay's We Need to Talk About Kevin, featuring a high-density performance by Tilda Swinton, took a harrowing look at the domestic damage wrought by a psychopathic son.
The capacity of CLF to produce high-performance structural components is demonstrated in the fabrication of an ultra-lightweight load-bearing lattice structure with outstanding stiffness-to-density and strength-to-density performance (compression modulus of 13.23 MPa and compressive strength of 0.20 MPa at a core density of 9 mg/cm3).
At low current densities, performance is improved by increasing electrolyte volume fraction to 50.0% and decreasing catalyst layer porosity to 12.0%.
